top of page

FRANYK v1 and BORYSLAV v1 — introducing our new ESCs

7 hours ago
2 min read

Our range of electronic speed controllers is growing. FRANYK v1 is entering beta testing with a 50% discount (limited to two units per customer), while BORYSLAV v1 is now available for large and high-speed copters. Both models run Bluejay firmware and support 6–8S Li-ion and LiPo batteries.


FRANYK v1 — beta testing a 65 A ESC


FRANYK 8S/65A/8bit v1 is rated for 65 A per channel and can handle peaks of up to 80 A for three seconds. The power stage uses 40 V / 310 A MOSFETs with a resistance of 0.89 mΩ. Their low resistance reduces energy losses and heat, while a 1,500 W TVS diode protects the ESC against brief voltage spikes.


FRANYK lets you choose where to place its two low-ESR filtering capacitors. Both are already fitted to the board in the beta version, giving the ESC dimensions of 50 × 50 × 20 mm. If your copter layout requires a different arrangement, the capacitors can be mounted along the frame.


If you try FRANYK in your build, we would appreciate your feedback!


BORYSLAV v1 — for large copters from 13 inches


We developed BORYSLAV 8S/100A/8bit v1 for large copters from 13″ and high-speed models powered by 8S batteries. It delivers 100 A per channel and can handle up to 120 A per channel for three seconds. The ESC’s maximum total current is 340 A.


BORYSLAV’s power and signal circuitry are located on two separate boards. For heat dissipation under high loads, we use a six-layer PCB with 2 oz of copper per layer. Four low-ESR capacitors are already fitted.


The ESC measures 70 × 70 mm, with 30.5 × 30.5 mm mounting-hole spacing for M3 screws.

 
 
bottom of page